2008 Ford Escape Center Console Removal

2008 Ford Escape Center Console Removal. The sliding tray and inside bin can be hooked on the side or rear of the console for extra storage. How to remove ford escape center consoleplease subscribe !!!also you can follow me on clays ac and auto repair on facebook why should you subscribe to my cha.

2008 Ford Escape XLT AWD 4dr SUV V6 Stock 4551 for sale
2008 Ford Escape XLT AWD 4dr SUV V6 Stock 4551 for sale from www.motorcarsexpress.com

Remove the two screws from the console bin. If you have a voltmeter, you can remove the horn fuse and check to see if there is continuity between the horn (non hot side) of the fuse and the car body. I took it apart before hand to speed the video up, remove at your own risk, this video is just for a basic reference.

All The Screws And Metal Inside Are Covered By Plastic Pieces.


The center console latch on many fords, 500, taurus and flex come to mind, is poorly constructed and prone to breaking. Side air bag module (right front) in right “b” pillar. The sliding tray and inside bin can be hooked on the side or rear of the console for extra storage.

Audio Control Module (Acm) Center Of Dash.


They show all these pieces just clipping together. The airbag , seatbelt and the control module change. Now the light stays on.

Use A Special Trim Removal Tool #Xyz To Gently Pry The Two Front Corners Near The Windshield, Between The Console And The Headliner. I Used A Broad, Flat Screwdriver, Worked Okay.


Installlation is the reverse & everything goes back together easy squeezy. If you need to dig into your doors, dash or. 2008 ford escape horn fuse keeps blowing after i would trace the wire from the horn and see if it was inadvertently damaged when the alternator was installed.

2008 Ford Escape Xlt Hello.


Position the seats forward and remove the 2 floor console rear bolts. When it does break, you must replace the console lid in it's entirety or deal with the annoyance of the lid popping up regularly forever. You'll also need to remove a phillips screw from the door pull cup.

The Lid Is Loose And I Need To Tighten It Up Or See What's Going On But I'm A Little Reluctant To Start Prying On The Trim Panels.


You'll need to remove the door panels to get at them, but that's not tough at all. How to remove ford escape center consoleplease subscribe !!!also you can follow me on clays ac and auto repair on facebook why should you subscribe to my cha. I have a 2013 manual, it shows that you first remove the center dash trim then open the console lid remove that trim then the trim piece around the emergency brake handle.