How To Tighten Belt On Craftsman Riding Mower. Slide the belt up and around the engine pulley. Test the tension in your existing lawnmower drive belt.
How To Adjust Belt Tension On Craftsman Riding Mower from beltposter.blogspot.com
Remove the cutting deck and battery. Pull the slack from the back of the tractor (transaxle pulley) and slide the belt on to the stationary and clutch idlers. Pull back the clamp holding the cable and tighten it so that the spring attached to it is stretched.
Push/ Jog The Belt Keepers On The Transaxle Pulley Down And Slip The Drive Belt Over The Transaxle Pulley.
Position the mower to change the lawn mower belt. Inspect the components on the mower such as the pulleys, belt, spring, and swingarm and check for any damage. Slide some even sized wood blocks under every corner of your mtd lawn tractor deck.
Check The Belt Again When The Screws Are Fitted.
Put your mower on parking mode. Turn the adjustment bolt on the side, top or bottom of the pulley counterclockwise with the ratchet and socket until the accessory belt is loose enough to remove. Slide the belt up and around the engine pulley.
Push The Belt Keepers On The Transaxle Pulley Down And Slide The Belt Over The Transaxle Pulley.
Detach the spark plug wire. Check the engine temperature before replacing the lawn mower belt. How to tighten the belt on a craftsman lawnmower, step by step:
Remove The Cutting Deck And Battery.
With a plier, disengage all the cotter pins connecting the deck to the lawn mower. Remove the blade drive belt from the mower deck by unwrapping it from around each pulley. Position your lawnmower on a leveled surface.
Because Drive Belts Operate At Such High Speeds, Any Problems Can Cause Cracks Or Fraying Almost Immediately.
Also, how do you tighten the belt on a riding. Take the lawnmower into your garage or a flat surface. Install the new belt in the same configuration as the old belt was.
