Kenmore Coldspot Refrigerator Ice Maker Not Working

Kenmore Coldspot Refrigerator Ice Maker Not Working. I have a kenmore coldspot model 106.55502400. Firstly, shut off all power and water supply to the fridge.

Kenmore coldspot model 106.56532400. Side by side and the
Kenmore coldspot model 106.56532400. Side by side and the from www.justanswer.com

If this doesn’t help, refer to the user’s manual—it may instruct you to perform a purge procedure or replace some parts. If your ice maker arm ejector plastic fingers are pointing at you or slighty. The water inlet valve which supplies water to the ice maker is designed to work.

Why Kenmore Refrigerator Ice Maker Not Working Ice Maker Assemblies.


If the control board is faulty, it may stop supplying power to the entire dispenser system. If the ice maker is not working the water pressure in the house might be too low. Most kenmore ice makers get water through a line connected to the water tap or the hot.

The Water Inlet Valve Which Supplies Water To The Ice Maker Is Designed To Work.


If no ice comes out, the door switch may be defective. Bad or defective ice maker this mechanical icemaker is used in many different refrigerators such as; Started noticing that there was no new.

Got A Kenmore Coldspot Side By Side (2002) Model # ***** Ice Maker Not Working The Unit Was Working Fine Until A Couple Of Weeks Ago.


Open one door of the refrigerator. The all right book, fiction, history, novel, scientific research, as competently as. If water is not getting to your kenmore ice maker, it can’t make ice.

The Icemaker Stopped Making Ice.


Disconnect the refrigerator from electric power. I have a kenmore coldspot model 106.55502400. How to fix an ice maker ice jam on a kenmore coldspot model:

Check The Water Lines In The Back Of The Refrigerator To See If There Is A Visible Kink Or.


Thanks to the design of kenmore refrigerators, the ice maker is pretty straightforward to replace. The water to the door works just fine. If only one dispenser part is not working, test each of the dispenser components before testing the.